2.
Disconnect the webcam cable from the ZIF connector on the system board (2), and then disconnect the
display cable from the ZIF connector on the system board (3).
3.
Open the display (1), remove the two Phillips 2.5 × 6.0 screws (2), and then detach the display panel (3).
4.
If it is necessary to remove the display panel (for non-glass display panel):
a.
Heating the display panel makes the panel easier to remove. If you heat the panel, heat it along the
top edge (1), left and right sides (2), and bottom edge (3).
Component replacement procedures
47