Operating The Application Example; Polling Diagnostic Data From The Station - Siemens SIMATIC S7-1200 CP 1242-7 V2 Application Example

6 Operating the Application Example

6.1 Polling diagnostic data from the station

Operating the Application Example
6
The following chapters show how to wirelessly monitor and control the remote
station. An existing connection of the remote station to the central station is
required for this (TCSB V3) (see
6.1 Polling diagnostic data from the station
Table 6-1
No.
1. Make sure that the engineering station is connected to the internet.
Note
Check the internet connection at your engineering station with the help of the
internet browser by calling up a random internet page.
Select the station "CP1242-7_V2_Teleservice" and establish the online connection.
2.
As PG/PC interface type, select "TeleService via mobile wireless" and as PG/PC
3.
interface "Mobile wireless TeleService board".
4. Establish the TeleService connection between engineering and remote station by
clicking on the mobile phone symbol.
TeleService with TCSB
Entry-ID: 56720905, V1.0,
Table 5-11, step no.
10/2016
8).
Action
31