Locating The Equipment In The Network; Cannot Locate The Equipment In The Network - Toshiba E-STUDIO 555 Troubleshooting Manual

Multifunctional digital systems
Hide thumbs Also See for E-STUDIO 555:
Table of Contents

Advertisement

6 TROUBLESHOOTING FOR NETWORK CONNECTIONS

Locating the Equipment in the Network

Cannot locate the equipment in the network

Problem Description
I cannot locate the equipment in the network.
Corrective Action
Improper settings may cause the problems in locating the equipment in the network. Try the checklist below to detect the
cause of the problem. If the problem remains unsolved, contact your service representative.
No. Check...
1
Is the startup page printed out? If not, wait until
the communication comes online. Examine the
protocol settings listed on the startup page. Are
they correct?
2
Print out a configuration page. Make sure that
there are not any discrepancies or inconsistencies
between the current network settings and your
network environment. Change the network
settings, if necessary. Use the Find Computer
utility from your Windows computer to locate the
equipment by its device name. Can you find the
equipment?
3
Can you locate other computers connected to the
same network?
4
Check the link LED activity on the hub and/or NIC
of the equipment and the client machine. Do the
hardware components appear to be functioning
properly?
5
Make sure that the device name for the
equipment is unique and verify that the WINS
and/or DNS server database are not causing
potential naming conflicts with the network
settings on the equipment. If necessary, change
the network settings on the equipment. After the
communication comes back online, can you see
the equipment in the network?
6
If the network environment is using complex
subnet or supernet structures, is the IP address
used by the equipment within the network
structures range of valid addresses?
70

Locating the Equipment in the Network

Yes
No
Corrective Action
Set up the proper protocols.
Next Step
Set up the proper protocol if required.
Once you have located the equipment, configure
the port that it is mapped correctly to the device.
Next Step
Check the network settings on the client computer
Next Step
to make sure that they are compatible with the
network settings on the equipment.
Contact your service representative.
Next Step
Set up the NetBIOS name of the device correctly.
Next Step
Contact your local network support specialist for
further assistance.
End

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

E-studio 655E-studio 755E-studio 855E-studio555

Table of Contents