Parts Name Of Remote Controller - Toshiba R410A Service Manual

PARTS NAME OF REMOTE CONTROLLER

Display section
All display items are shown in right figure for the explanation.
Only selected contents are displayed in actual operation.
• When turning on the leakage breaker at the first time, [SET DATA]
flashes on the display part of the remote controller. While this
display is flashing, the model is being automatically confirmed.
Accordingly, wait for a while after [SET DATA] display has disap-
peared, and then use the remote controller.
2
3
4
5
6
7
8
1
SET DATA display
Displayed during setup a timer.
2
Operation mode display
The selected operation mode is displayed.
3
CHECK display
Displayed while the protective device works
or a trouble occurs.
4
Timer time display
Set time by the timer is displayed.
(When a trouble occurs, the check code is
displayed.)
5
Timer SETIN setup display
When pushing the Timer SET button, the
display of the timer is selected in order of
[OFF] [OFF] repeat OFF timer
[ON]
No display.
6
Filter display
If "FILTER " is displayed, clean the air
filter.
7
UP/DOWN grille display
8
Ventilator operation display
9
Flap position display
1
9
SET DATA
UNIT No.
SETTING TEST
R.C. No.
10
SWING display
Displayed during up/down movement of the
flap.
11
Set up temperature display
The selected set up temp. is displayed.
12
Remote controller sensor display
Displayed while the sensor of the remote
controller is working.
13
PRE-HEAT display
Displayed when the heating operation starts or
defrost operation is carried out.
While this indication is displayed, the indoor
fan stops or the mode changes in LOW.
14
No function display
Displayed if there is no function even if the
button is pushed.
15
Fan mode display
The selected fan mode is displayed.
16
TEST run display
Displayed during a test run.
34
CODE No.
SET DATA
UNIT No.
SETTING TEST
R.C. No.
UNIT
SET CL
CODE No.
11
13 14
15 16
(AUTO)
(HIGH)
(MED.)
(LOW)
Display
section
Operation
section
10
12