Getting Started; Installing The Base; Installing The Handset - Topcom BUTLER 5500 User Manual

1 GETTING STARTED

1.1

INSTALLING THE BASE

For installation, do the following:
• Plug one end of the adaptor into the outlet and the other end into the adapter jack on the
bottom of the telephone.
• Connect one end of the telephone cord with the wall phone jack and the other end to the
bottom of the telephone.
• Put the telephone-and AC power line cord in the base quides as shown on the picture below:
1.2

INSTALLING THE HANDSET

• Open the battery compartment (see below).
• Insert the batteries respecting the (+ and -) polarity.
• Close the battery compartment.
• Leave the handset on the base unit for 20 hours. The Line/Charge indicator
up.
back view of hand-set
Before you use the telephone for the first time, you must first make sure the battery is charged for 20 hours. If you do
not do this, the telephone will not work optimally.
1.3 IF YOU HAVE PURCHASED A TWIN/TRIPLE VERSION
If you have purchased a Twin or triple verion
• Plug one end of the adaptor into the outlet and the other end into the adapter jack on the bottom of the charger.
• Insert the battries inside the handset
• Charge the handset for at least 20 hours.
4
Power cable
Telephone cord
TEL
Cover
Rechargeable
Batteries
Topcom Butler 5500
(LED) on the base unit will light
Topcom Butler 5500