Removing An Interface Card; Installing/Removing A Sfp/Sfp+/Qsfp+ Transceiver Module - NEC QX-S5500G Series Installation Manual

Installation Guide
QX-S5500G Series Ethernet Switches
 NOTE:
When LSWM5SP8PM was inserted, the chassis depth increases by 55 mm (2.17 in).

3.8.2 Removing an interface card

To remove an interface card:
1) Wear an ESD wrist strap and make sure it makes good skin contact and is correctly
grounded.
2) Use a Phillips screwdriver to completely loosen the captive screw on the interface
card.
3) (Optional.) If the interface card has an ejector lever, rotate out the ejector lever. Skip
this step if the interface card does not have an ejector lever.
4) Gently pull the interface card along the guide rails until it completely comes out of the
switch chassis.

3.9 Installing/Removing a SFP/SFP+/QSFP+ transceiver module

WARNING:
Do not touch the connector terminal when you insert and remove the SFP/SFP+/QSFP+ transceiver module.
You can install some SFP/SFP+/QSFP+ transceiver modules as needed. When using
QSFP+ by the QX-S5524GT-4X1C, QX-S5548GT-4X1C or QX-S5524GP-4X1C, mounting
of LSWM5QP2P is needed.
For more information about a SFP/SFP+/QSFP+ transceiver module available for the
switches, see "Appendix C Ports and LEDs".
Figure 3-36 The LSWM2XGT8PM interface card installed in the switch
3-29
3. Installing the switch