Sfp+ Port - NEC QX-S5500G Series Installation Manual

Installation Guide
QX-S5500G Series Ethernet Switches
Transceiver module
1000BASE-BX40-D-SFP
1000BASE-T-SFP
 NOTE:
Use SFP transceiver module items of NEC designation for the transceiver module and the cable used for

switch.
There is a changed possibility for supported transceiver module and cable.


10.1.6 SFP+ port

The QX-S5500G Series provide 4 SFP+ ports into a front panel. Also it's possible to mount
SFP+ port of 2 or 8 by loading an expansion interface card into the rear.
You can plug the 1000BASE-X SFP transceiver modules in Table 10-5. You can plug the
10Gbps SFP transceiver modules in Table 10-6. SFP+ cable is inserted in SFP+ port as
need. You can plug the 10Gbps SFP+ transceiver modules in Table 10-7. To expand IRF
fabric, it's possible to use a SFP port as the IRF fabric physical port to connect to switch.
SFP+ cable is indicated on Figure 10-1. An indicated 40G QSFP+/10G*4 SFP+ copper
cable can also be used for Figure 10-3.
Transceiver module
1000BASE-SX-SFP
Central
wavelength
1490 nm
－
Table 10-5 SFP+ transceiver modules available for the1000Mbps SFP ports
Central
wavelength
850 nm
Connector Fiber diameter
9/125 μm single-mode optical
LC
fiber
RJ-45 Category-5 twisted pair
Connector Fiber diameter
50/125 μm
optical fiber
LC
62.5/125 μm
optical fiber
10-4
10. Appendix C Ports and LEDs
Max
transmission
distance
40 km
(131233.60ft)
100
(328.08ft)
Max
transmission
distance
multi-mode 550
(1804.46 ft.)
multi-mode 275 m (902.23
ft.)
m
m