Disassembly / Assembly And Configuring The Cutting Mechanism; Storage; Transport - MTD WOLF Alpha 95.165 H Manual

EN
Every 50 operating hours
Have dirt and grass residue removed from the
Î
drive gear by a workshop.
Have drive belts, blade shafts and clamping rollers
Î
checked by a workshop for wear and damage.
Every 2 months
Only for battery type 2: Fill the battery cells with
Î
distilled water up to 1 cm below the fill opening.
As required
Charging the battery:
If you are not going to use the device for lengthy
Î
periods, remove the battery from the device.
Charge the battery every 6–8 weeks, as well
Î
as prior to putting back into operation following

storage.

Note
Pay attention to the notes in the operating
instructions of your battery charger.
Replacing fuses:
Replace defective fuses with those of the same
Î
power.
Note
The fuse is located on the main cable har-
ness between the battery and the motor.
Only have a defective fuse replaced by a
workshop.
Once per season
Clean the spark plugs and adjust the electrode
Î
gap / replace the spark plug (see motor manual).
Have the rear wheel axles lubricated by a work-
Î
shop with special water-repellent grease.
Arrange for a specialist workshop to sharpen or
Î
replace the cutting tool.
Disassembly / assembly and configuring
the cutting mechanism
The hanger/lifting mechanism is spring-
loaded and may spring upwards as soon
as the cutterdeck is disconnected from the
lifting mechanism.
When releasing the cutting height
adjustment lever with the cutting
mechanism removed, it can spring violently
upwards.
Note
Only have this work performed by a work-
shop.
24
CAUTION !

Disassembly / assembly and configuring the cutting mechanism

Attention!
Material damage to the device
¾ Store the device in a clean and dry room.
¾ Protect the device against rust in the event of
lengthy storage.
¾ Protect the device against frost.
Clean the device and the grass collector.
Î
Wipe all metallic parts down with an oiled cloth or
Î
use spray oil to protect against rust.
Charge the battery.
Î
Remove the battery in the event of lengthy
Î
storage (e.g. in winter).
Charge the battery every 6–8 weeks, as well as
Î
prior to re-installation, in the event of lengthy
storage.
Drain the fuel and shut the motor down – see
Î
motor manual.

Transport

Note
The device is not permitted for use on roads
(as required by German road traffic regula-
tions).
Short distances
To change the location of use, only drive short
Î
distances with the lawn tractor.
Long distances
Danger posed by unstable and insecure
ramps
ÂDanger posed by heavy persons and
material damage
¾ If you are driving the device onto a trailer
or lorry, first ensure that the ramp is
stable and secure.
Danger posed by inadequate fastening
ÂTurbulence during transport
¾ If you are transporting the device in
a trailer or lorry, fasten and secure it
properly.
Use a transport vehicle for larger distances.
Î
Push the device by hand in idle into/onto the
Î
transport vehicle.
Engage the parking brake and secure the device
Î
against slipping.
Storage
WARNING !
WARNING !