Connect The Camera To The Network - Bosch MIC IP starlight 7000i Installation Manual

MIC IP starlight 7000i
Figure 11.1: Connectors from the base of the MIC camera
1 RJ45 (Cat5e/Cat6) connector (male) (supporting High PoE) for power and
communication between a Bosch model of High PoE Midspan or a VJC-7000-90
2 24 VAC power wires (24 gage) to VG4-A-PSU1 or VG4-A-PSU2 (if not using a PoE
network)
3 Chassis (Earth) ground wire (18 gage) with connector lug
4 RS-485 connections for communication to / from the MIC-ALM-WAS-24
5 Liquid-tight cord grip in the base of the camera
* For more information, refer to the installation manual Power Supply Units (AUTODOME VG5-
and MIC IP Camera Models) (shipped with VG4-A-PSU1 and VG4-A-PSU2).
Note: If the MIC camera will be installed directly to a mounting surface, instead of onto a MIC
DCA or a MIC wall mount bracket, Bosch recommends using the connector kit for your model
of camera to protect the connections against moisture and dust particles. Each kit provides
components for connecting as many as 5 MIC cameras.
MIC-IP67-5PK MIC7000 IP67 Connector Kit
Not using the IP67 Connector Kit will void the camera warranty.
Note: The PoE connection is not intended to be connected to exposed (outside plant)
networks.
Seal the base of the camera against moisture ingress (standing water).
11.5

Connect the Camera to the Network

Note: The total length of Cat5e/Cat6 Shielded Twisted Pair (STP) cable must be less than 100
m (328 ft) between the camera and the head-end system.
1. Make the appropriate network connections depending on the power source of your IP
network:
Bosch Security Systems
Description
Installation Manual
Connections | en 47
Wire Color
Line (L) = Black
Neutral (N) = White
Green
+ = Purple
- = Yellow
GND = Brown
2019-11 | 2.1 |