Connections; About Camera Power And Control; Power Source Options - Bosch MIC IP starlight 7000i Installation Manual

MIC IP starlight 7000i
11

Connections

11.1

About Camera Power and Control

The camera incorporates a network video server that encodes video images and PTZ control
commands for transmission over a TCP/IP or UDP/IP network.
With its H.264 or H.265 encoding, it is ideally suited for IP communication and for remote
access to digital video recorders and multiplexers. Use existing networks to achieve quick and
easy integration with CCTV systems or local networks. Several receivers can receive video
images simultaneously from a single camera.
11.2

Power Source Options

The camera can be powered by a network compliant to High Power-over-Ethernet using a
Bosch model of High PoE Midspan (sold separately). With this configuration, only a single
cable connection
(Cat5e/Cat6 Shielded Twisted Pair (STP)) is needed to view, to power, and to control the
camera.
For maximum reliability, the camera can be connected simultaneously to a High PoE Midspan
and a separate 24 VAC power source. If High PoE and 24 VAC are applied simultaneously, the
camera usually selects the High PoE Midspan and will draw minimal power from the auxiliary
input (24 VAC). If the High PoE Midspan power source fails, the camera switches power input
seamlessly to 24 VAC. After the High PoE Midspan power source is restored, the camera
switches power input again to the High PoE Midspan.
Bosch recommends 24VAC power output of 24V at 100VA, 4A with a slow blow fuse.
The power supply must be certified to UL/IEC 60950-1 2nd Edition, AM1+AM2 or UL/IEC
62368-1 2nd Ed, Output 24 VAC, LPS, +65 °C (+149 °F) min.
In the table below, an "X" identifies the power source options for MIC IP camera models.
CAMERA MODELS
Bosch recommends only a midspan power source for models with an attached illuminator.
The table below identifies the power devices that can be connected simultaneously to the
camera.
60 W midspan (NPD-6001B)
95 W midspan (NPD-9501A)
VIDEOJET connect 7000 (VJC-7000-90)
Notice!
Connect the 24 VAC connections from the MIC camera to the heater output of the power
supply (VG4-A-PSU1 or VG4-A-PSU2).
Bosch Security Systems
60 W midspan
Models with
illuminator
Models without
illuminator
If power is supplied from:
Installation Manual
95 W midspan
X
X X
Camera can receive power simultaneously from:
24 VAC PSU: VG4-A-PSU1 or VG4-A-PSU2
Connections | en
VIDEOJET connect
7000
X
X
2019-11 | 2.1 |
45
24 VAC
PSU
X