Upgrading Firmware; Reboot - Planet WGR-500-4P User Manual

4.6.3

Upgrading Firmware

This page provides the firmware upgrade of industrial wall-mount Gigabit router as shown in
Object
Choose File
Upload
Reset
4.6.4

Reboot

This page enables the device to be rebooted from a remote location. Once the Reboot button is pressed, users
have to re-log in the Web interface for about 60 seconds later as
Object
Reboot
You can also check the SYS LED on the front panel to identify whether the System is loaded
completely or not. If the SYS LED is blinking, then it is in the firmware load stage; if the SYS
LED light is on, you can use the Web browser to log in the industrial wall-mount Gigabit router.
User's Manual of WGR-500-4P and WGR-500-4PV
Figure 4-55: Firmware upgrade
Description
Press the button to select the firmware.
Press the button upgrades firmware to system.
Press this button to cancel the file.
Figure 4-56
Figure 4-56: Reboot
Description
Press the button to reboot system.
90
Figure 4-55.
is shown below: