Tiger JD 5083E Mounting And Operating Instructions page 78

GREASING GROUND ROLLER SHAFT – FLAIL
Locate grease zerks on each end of roller tube at lower rear of head. Normal
conditions require one or two pump in each bearing, using Lithium-Complex
Extreme Pressure grease conforming to NLGI2-ISO 320 specifications. This is to
be done with a standard grease gun daily or at 8 hour intervals. CAUTION:
Over greasing may cause premature seal failure.
GREASING THE IDLER TENSION ARMS
Locate the access holes and grease zerks in the belt shields of the side and rear
flails. Normal conditions require one pump daily or every 8 hours of service with
multi purpose grease.
Locate the idler tensioning rod for each flail. Loosen the locking nut. Turn the
adjusting nut until the washer in between the spring and nuts is flush with the spring
housing or guide. Tighten locking nut securely. For standard cut on side flail adjust
until the spring washer is flush with the top of the spring housing, as shown below.
Use this same method to adjust hydraulically driven rear flails.
Side & Rear flail Maintenance Section 4-20
MAINTENANCE
IDLER TENSIONING