Auto Config; Firmware Upgrade; To Update The Firmware Via A Tftp Server - NEC GT200 User Manual

Auto Config

Configuration file can be retrieved. Set the following:
1. Select Enable in Auto Configuration field to activate the setting of the auto configuration.
2. Select Enable in DHCP OPTION 66 field to allow the configuration file to be retrieved by DHCP option66 settings.
Select Disable in DHCP OPTION 66 field to manual specified location of configuration file. Next, enter the
information provided by your ITSP or MIS in each field.

Server: Input configuration file server address. TFTP is supported.

Path: Input the configuration file path.

User: Input user name of accessing configuration.

Password: Input password of accessing configuration.
3. Click Submit to save your settings or Reset to cancel.

Firmware Upgrade

To update the firmware via a TFTP server:

1. Click System Settings, Firmware Upgrade. The following screen will be displayed.
2. Set the TFTP server information.
3. Click Submit to save your settings or Reset to cancel.
Note: In the TFTP Server IP column, a file name without extension such as "2700x.16.1.00X.Y" (X and Y are firmware
version number.)" is also necessary after a server address. You can confirm the name from a firmware file.
Caution: During firmware upgrading, DON'T power off the VoIP phone, it causes permanent damage.
Chapter 4 Web Configuration
25