For Sv8300; For Sv8100 - NEC GT200 User Manual

2. Press the MENU/EXIT key, then use the UP and DOWN keys to switch from YES/NO. Press SELECT again to
confirm or to cancel and return to previous menu level.
Note: If you have more than one SIP account, repeat the settings in step 1 to configure additional SIP accounts.

For SV8300

1. Select one of the ten SIP accounts to display the submenu. The following items are required:

Registration: Enable / disable this account, set to "Enable" on SV8300.

Send Register: Enable / disable sending SIP account information, set to "Enable" on SV8300.

Reg. ID: Input the registration ID, it is "Extension number" registered on SV8300.

Display Name: Input the user name. The user name will be shown on the terminal display when the phone is
idle.

Auth. Name: Input the Authentication Name used for authentication. It can be identical to or different from SIP
Registration ID. It is "Extension number" registered on SV8300

Password: Input the register password.

Reg. Server: Input the registration server IP address, "(IP Address of SV8300): (port number)", a port number
is required. The default value of the SV8300 is "5070"

Reg. Port: Input the registration server Port.

Proxy Server: Input the proxy server IP address.

Proxy Port: Input the proxy server port number.

Outbound Proxy: Input the outbound proxy server IP address.

Outbound Proxy Port: Input the outbound proxy server port number.

Expire time: User can set the timeout duration for registration request, it should be "120" or more.

DTMF Type: Input the DTMF type options: RFC2833 / In-Band

Keep Alive: To keep connected to the server by period time. Typically enabled to instruct the phone to send
SIP keep-alive message for maintaining a "pinhole" in the user's firewall through which SIP messages can pass.

MWI: Enable / disable to ask server auto provide Message Waiting Indicator.

Voice Mail: Input the speed dial number for your SIP reg. server or IP-PBX Voice Mail system.

Save: To save your settings.
2.
Press the MENU/EXIT key, then use the UP and DOWN keys to switch from YES/NO. Press SELECT again to
confirm or to cancel and return to previous menu level.
Note: If you have more than one SIP account, repeat the settings in step 1 to configure additional SIP accounts.

For SV8100

1.
Select one of the ten SIP accounts to display the submenu. The following items are required:

Registration: Enable / disable this account, set to "Enable" on SV8100.

Send Register: Enable / disable sending SIP account information, set to "Enable" on SV8100.

Reg. ID: Input the registration ID, it is "Extension number" registered on SV8100.

Display Name: Input the user name. The user name will be shown on the terminal display when the phone is
idle.

Auth. Name: Input the Authentication Name used for authentication. It can be identical to or different from SIP
Registration ID. It is "Extension number" registered on SV8100

Password: Input the register password.

Reg. Server: Input the registration server IP address, "(IP Address of SV8100): (port number)", a port number
is required. The default value of the SV8100 is "5070"

Reg. Port: Input the registration server Port.

Proxy Server: Input the proxy server IP address.

Proxy Port: Input the proxy server port number.

Outbound Proxy: Input the outbound proxy server IP address.

Outbound Proxy Port: Input the outbound proxy server port number.
Chapter 3 MMI Configuration
16