Operation - Thermador HGEW36FS Use And Care Manual

OPERATION

IMPORTANT: The most effective method of
removing vapors produced during cooking
is to:
Switch the ventilator ON prior to
cooking or as soon as you begin
cooking.
Switch the ventilator OFF
a few minutes after you have finished
cooking.
Set the glass plate in cooking
position.
Display for fan setting
Light Reduce fan
speed
Fan OFF
Acoustic signal:
When a button is pressed, this is verified
by an acoustic signal.
Switching off the acoustic signal:
Simultaneously press buttons 0 and +
until a signal is emitted after approx. 3
seconds.
Switching on the acoustic signal:
Repeat the process.
6
cooking position
Fan follow-on
Fan ON and
increase speed
Switching the fan ON
Press the + button or pull out the filter
drawer.
Setting the required fan speed:
Press the + button.
The fan speed is increased by one step.
Press the – button.
The fan speed is reduced by one step.
Switching the fan OFF:
Press the 0 button.
The displayed
{
afterwards.
Or:
Keep pressing the – button until the fan
switches off.
The displayed
{
afterwards.
Intensive setting:
Maximum power is obtained at the
intensive setting.
It is only required for short intervals.
Keep pressing the + button until a
appears in the display.
If the intensive setting is not cancelled by
hand, the
fan will automatically switch back to step
after 10 minutes.
}
Fan follow-on:
Press the button or push in the filter
!
drawer.
The fan runs for 10 minutes at setting 1.
At the same time a dot flashes in the
display.
Then the fan switches off automatically.
Lighting:
Briefly press the
light on and off.
The light can be switched on at any
time, even though the fan is switched off.
Adjusting the brightness:
Hold down the
a
desired brightness is obtained.
goes out shortly
goes out shortly
ç
button to switch the
a
button until the