Custom Panel Series Side Panels; Installation Requirements; Tools And Parts - Thermador KBULT3651A Installation Instructions Manual

Built-in refrigerators bottom mount models
Hide thumbs Also See for KBULT3651A:
Table of Contents

Advertisement

Available languages

Available languages

C us t om Pa ne l S e r i e s S i d e
Pan e l s
Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed at the end of a cabinet run. You
may choose an Inset or Recessed Inset panel installation.
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type
of installation you are planning.
NOTES:
The dimensions shown are actual product dimensions
and may not reflect the needed installation dimensions.
The side panel should be a minimum of
thick to prevent warping.
If the opening depth is 25 in. (63.5 cm) or more, you may
want to install a support board on the rear wall.
Refrigerator
Side Trim
3
/
"
8
(9.7 mm)
1
/
"
16
(1.5 mm)
1
/
"
8
(3.2 mm)
12
in. (1.27 cm)
Overlay
23
3
/
"
8
(59.40 cm)
3
/
"
16
(4.5 mm)
Inset Installation Dimensions
1. Measure the distance from point A (as shown) to the back
wall. Add
in. (.8 mm) to this measurement to allow the side
panel to fit into the trim.
2. If the panel is more than
edge to allow the side panel to fit into the trim.
A
Recessed Inset Installation Dimensions
1. Measure the distance from point A (as shown) to back wall.
2. Route the front edge of the support board or attach a
(9.5 mm) board to hold the panel in the cabinet side trim.
A
INSTALLATION
REQUIREMENTS
Too l s a nd Par t s
IMPORTANT:
Installer: Leave Installation Instructions with the homeowner.
Homeowner: Keep Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector's use.
Tools needed:
Make sure that you have the tools necessary for proper
installation:
Hand drill or electric drill
(properly grounded)
Drill bits
Two adjustable wrenches
Phillips screwdriver
Small level
Appliance dolly
in. (9.5 mm) thick, route the front
T27 flat-head 6 point
driver
in. nut driver
in. and
in. open-end
wrenches
in. Allen wrench
in. socket wrench
Tape measure
in.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kburt3671aKburt3651aKbult3661aKburt3661aKbult3671a

Table of Contents