Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
Media and Additional Parts
Description
Parts Catalog
Operator's Manual
WARNING
If you leave the key in the ignition switch,
someone could accidentally start the engine
and seriously injure you or other bystanders.
Remove the key from the ignition switch
before you do any maintenance.
DANGER
If the engine is started and the PTO shaft is
allowed to rotate, serious injury could result.
Do not start the engine and engage the PTO
lever when the PTO shaft is not connected to
the gearbox on the cutting unit.
Description
No parts required
Completion kit (sold separately)
Castor wheel assembly
Right lift arm
Left lift arm
Pivot pin
Cotter pin
Thrust washer
Clevis pin
Hairpin cotter
Height-of-cut collar
Clevis pin
Hairpin cotter
Bolt (1/2 x 3/4 inch)
Washer
No parts required
No parts required
Qty.
–
1
2
1
1
2
2
4
4
2
2
2
2
2
2
–
–
Qty.
1
Read material before operation
1
Note:
Determine the left and right sides of the
machine from the normal operating position.
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key.
7
Use
Prepare the machine.
Install a completion kit.
Install the castor wheel assemblies.
Install the lift arms.
Install the cutting units
Connect the PTO shaft to the cutting
unit gearbox.
Grease the machine.
Use
Advertisement
Table of Contents
