CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Important:
The fasteners on the covers of this machine are designed to remain on the cover after
removal. Loosen all the fasteners on each cover a few turns so that the cover is loose but still attached,
then go back and loosen them until the cover comes free. This prevents you from accidentally stripping
the bolts free of the retainers.
Lubrication
Service Interval: Every 50 hours Lubricate the
grease fittings immediately after
every washing.
The machine has grease fittings that you must
lubricate regularly with No. 2 lithium grease.
Lubricate the following areas:
•
Castor fork shaft bushings (4)
Figure 15
•
Spindle shaft bearings (3) (located under the
pulley)
(Figure
16)
Figure 16
•
Idler arm shaft bearings
•
Lift arm pivots, front (2)
(Figure
15).
g012234
(Figure
16)
(Figure
17)
1. Lift arm
2. Clevis pin
•
Lift arm pivots, rear (2)
g011557
Checking the Lubricant in
the Gearbox
Service Interval: Every 50 hours
The gearbox in designed to operate on SAE 80–90
weight gear lube. Although the gearbox comes with
lubricant from the factory, check the level before
operating the cutting unit. The gearbox capacity is
283 ml (12 fl oz).
1.
Park the machine and cutting unit on a level
surface.
17
Figure 17
3. Hairpin cotter
4. Pivot support
(Figure
18)
Figure 18
g012235
g010550