Siemens 7XV545 Product Information page 8

Product Information
Communication Converters
Read and understand these instructions and the relevant manual before installing,
operating, or maintaining the device.
You will receive manuals in the download area on our homepage
http://www.SIPROTEC.com
Disclaimer of Liability
Although we have carefully checked the contents of this publication for conformity with the hardware and software described, we cannot guarantee
complete conformity since errors cannot be excluded.
The information provided in this document is checked at regular intervals and any corrections that might become necessary are included in the next
releases. Any suggestions for improvement are welcome.
Subject to change without prior notice.
Copyright
Copyright © Siemens AG 2017 – All Rights Reserved
The reproduction, transmission or use of this document or its contents is not permitted without express written authority. Offenders will be liable for
damages. All rights, including rights created by patent grant or registration of a utility model or design, are reserved.
Registered Trademarks
SIPROTEC, SINAUT, SICAM und DIGSI® are registered trademark of SIEMENS AG. All other product and brand names in this product information
might be trademarks, the use of which by third persons for their purposes might infringe the rights of their respective owners.
Notes on Safety
This document contains notes that must be adhered to for your own personal safety and to avoid damage to property. However, it does not constitute a
complete description of all safety measures required for installation, service, and maintenance of the equipment (module, device) in question. Details
are to be taken from the device manual and those are mandatory.
WARNING
Danger of severe personal injury or substantial damage to property
Hazardous voltages may occur in devices and modules during operation
depending on the design and application.
 Always observe the instructions given in "Qualified Electrical
Engineering Personnel" below.
Qualified Electrical Engineering Personnel
Only qualified electrical engineering personnel may commission and operate the equipment (module, device) described in this document.
Qualified electrical engineering personnel in the sense of this document are people who can demonstrate technical qualifications as electrical
technicians. These persons may commission, isolate, ground and label devices, systems and circuits according to the standards of safety engineering.
Use as Prescribed
The equipment (device, module) may only be used for such applications as set out in the catalogs and the technical description, and only in
combination with third-party equipment recommended and approved by Siemens.
If the device is not used in accordance with this product information, the scheduled protection is impaired.
Correct and safe operation of the product requires adequate transportation, storage, installation, and assembly as well as appropriate use and
maintenance.
During the operation of electric equipment, it is unavoidable that certain parts of this equipment will carry hazardous voltages. Severe injury or material
damage can occur if the appropriate measures are not taken:

Before making any connections at all, ground the equipment at the grounding terminal.

Hazardous voltages can be present on all switching components connected to the power supply.

Even after the supply voltage has been disconnected, hazardous voltages can still be present in the equipment (capacitor storage).

Equipment with current transformer circuits must not be operated openly.

The limiting values indicated in the product information and the manuals must not be exceeded; this also refers to testing and commissioning.
Unrestricted Product Information
C53000-X1150-C601-2,
7XV545, 7XV565, 7XV58
8
Edition 02.2018