Manual Regeneration - Pentair Evolio 255 Series User Manual

User Guide Evolio
7 . Operation
7.1. Display
7.1.1. During operation
Depending of the clock mode programmed, display shows:
• P10=0, current time in 12 am/pm alternating with remaining capacity in US gallons;
• P10=1, current time in 24 hours alternating with remaining capacity in cubic meters.
• The current time in 24 hours is displayed:
• The remaining capacity (in m
7.1.2. During regeneration
• A "C#" is displayed to show the current cycle;
• total regen time remaining in minute is displayed on screen;
• you can press and hold
7.2.

Manual regeneration

MANDATORY
The controller must be in service in order to enable this procedure.
NOTE

The unit returns to normal operation if no buttons are pressed within 30 seconds.
7.2.1. Manual delayed regeneration
A Press once for delayed regeneration.
→ The regeneration will start on the scheduled time. See chapter 5.1. Home screen, page 12.
→ A flashing regen symbol will be displayed.
NOTE

To cancel: press
7.2.2. Immediate regeneration
A Press and hold for 5 seconds to initiate immediate manual regeneration.
→ A solid regeneration icon will be displayed.
→ Camshaft starts rotating to cycle C1.
7.2.3. To advance regeneration cycles
A Simultaneously press
→ An hourglass will display while the camshaft is moving.
→ When the camshaft reaches next cycle, "C2" will be displayed.
16 / 116
3
) is displayed:
to show current cycle time remaining.

again. The regen symbol disappears.
and to advance to the next cycle.
Ref. MKT-UG-037 / C - 14.11.2019