Husqvarna 531RB Workshop Manual page 54

5. Remove the protective plates (K and L).
K
7.14.3 To disassemble the bevel gear
Note: The illustrations in this section shows one of the
models, but the procedure is the same for the 2 models.
To remove the gearbox on page 52
1. Do the steps in
To remove the gearbox on page 53 .
or
2. Use pliers to remove the snap rings (O and P).
O
54 - Repair instructions
3. Put on protective gloves. Use a hot air gun to
increase the temperature of the angle gear to
approximately 110°C - 140°C. Hit the gearbox
against a wooden block.
L
4. Remove the input shaft assembly (Q) from the gear
housing. Remove the snap ring (S) from the input
shaft (V). Remove the bearings (T and U).
Q
P
5. Increase the temperature of the gear housing to
approx. 140°C.
R
935 - 001 -
V
U
T
S