Husqvarna 531RB Workshop Manual page 46

5. Lubricate the crankshaft with some oil. Move the
crankcase half on the clutch side into position.
6. Tighten the 4 screws in turns. Make sure that the
crankshaft can rotate easily.
46 - Repair instructions
7. Put the small bushing on the crankcase. Put an
assembly sleeve on the crankshaft on the clutch
side to prevent damage to the seal ring. Lubricate
the crankshaft with oil and install the seal ring.
8. Attach the heat shield (B) with the screw (A).
9. Assemble the remaining parts in the opposite
sequence to how they were disassembled.
B
A
935 - 001 -