Husqvarna 531RB Workshop Manual page 34

6. Remove the 2 screws (F) and remove the ignition
module from the clutch drum assembly. Replace the
ignition module, if it is necessary.
Note: Make sure that you see the position of the
clamp.
7. Carefully remove the cable guide and disconnect the
cable.
8. Remove the spark plug and put a piston stop in the
spark plug hole to prevent movement of the piston.
34 - Repair instructions
9. Remove the 2 screws (G) that hold the centrifugal
clutch (H). Remove the centrifugal clutch. Remove
the 2 washers (I) between the screws and the
centrifugal clutch. Remove the 2 screws (J) between
the flywheel and the centrifugal clutch.
F
10. Remove the nut and remove the flywheel. Remove
the key.
11. Examine the ignition system. Refer to
the ignition system on page 35 .
12. Assemble the ignition system in the opposite
sequence. Make sure that the key is in the correct
position when you install the flywheel.
J
H
G
I
To examine
935 - 001 -