3. Attach the recoil spring in the groove in the starter
pulley.
4. Lubricate the recoil spring and the stub axle of the
starter pulley with cold resistant grease or thin oil.
18 - Repair instructions
5. Put the starter rope through the opening in the
starter housing.
6. Put the starter pulley (D) on the axle of the starter
housing. Make sure that the recoil spring (F) is in the
groove (G) in the axle. Lubricate the spring (C) and
install it in the starter pulley. Install the starter pulley
driver (B) to the starter pulley and attach the screw
(A). Install the plastic cover (E).
A
B
C
D
E
F
G
935 - 001 -