Disabling And Enabling Protocols; Determining Which Protocols Are Enabled - Tektronix Phaser 850 Setup Manual

Disabling and Enabling Protocols

After your network configuration is complete, you may want to disable protocols that you
are not using to avoid unnecessary network traffic. There are four ways to disable
protocols:
Use the printer's front panel; see Disabling and enabling protocols: Phaser 850 front
panel on page 42.
In NetWare environments, you can use the PhaserShare Administrator; see Disabling
protocols: PhaserShare Administrator on page 42.
With a TCP/IP connection and a World Wide Web browser, you can use PhaserLink
Printer Management Software; see Disabling protocols: PhaserLink Printer
Management Software on page 43.
Send the appropriate PostScript utility file to the printer. See the README files on
the printer's CD-ROM. The PC README file is in the UTILS directory; the Macintosh
README file is in the Network Utilities folder.
You can enable protocols by the same procedures; just select the command to enable a
protocol rather than disable it.

Determining which protocols are enabled

All protocols can be enabled and disabled. The Configuration Page reports which
protocols are enabled. If a protocol is enabled, the field for that protocol lists the current
parameters. If the protocol is disabled, the field for that protocol contains an entry reading
Disabled.
Networking Setup Guide
Disabling and Enabling Protocols
41