Unpacking Instructions - Murray 22 Instruction Book

WARNING: Before doing any
assembly or maintenance to the
mower, remove the wire from the
spark plug.
NOTE: In this instruction book, left and
right describe the location of a part with the
operator standing behind the handle.

UNPACKING INSTRUCTIONS

The mower was fully assembled at the factory.
When the mower was put in the carton, the
handle was put in the storage position. To put
the handle in the operating position, follow the
steps below.
Handle
1. Remove the mower from the carton.
2. Remove all packing material from the
mower and the handle.
NOTE: The height of the handle can be
set at either a HIGH or LOW position.
See "How To Adjust The Handle
Height".
3. Raise the lower handle. Make sure the
lower handle is between the locking tabs
(Figure 1). Tighten the wingnuts.
4. Put the upper handle in the operating (up-
right) position. Tighten the wingnuts.
CAUTION: Be careful when you fold or
raise the handle. Do not damage the
cables. A cable that is bent will not work
correctly. Before you use the unit, re-
place a bent or damaged cable.
5. Hold the engine stop lever against the han-
dle. Slowly pull the recoil-start grip. To at-
tach the recoil-start grip to the rope
guide, twist the rope through the rope
guide mounted on the right side of the han-
dle (Figure 2).
Rear Wheels (Hi-Wheel Models With
Axle Knobs)
NOTE: If wheels are already factory
mounted, go to the next section.
1. Remove the washers and axle knobs
from the axle bolts (Figure 3).
F-050414L
PREPARATION
2. Mount the rear wheels onto the axle bolts
11
and fasten with the washers and axle
knobs.
Lower Handle
Locking
Tabs
Handle
Bracket
Recoil-Start
Grip
Rope
Guide
Rear Wheel
Upper Handle
Wingnut
Wingnut
Figure 1
Figure 2
Axle Knob
Washer
Axle Bolt
Figure 3