Table of Contents
Advertisement
PREPARATION
UNPACKING INSTRUCTIONS
The mower was fully assembled at the factory.
When the mower was put In the carton, the
handle was put in the storage position. To put
the handle in the opiating
position, follow the
steps below.
1. Remove the mower from the carton.
2. Put the lower handle In the operating pesl-
tlon. Make sure the lower handle Is be-
twsen the Iocldng tabs (Rgure 1).
3. Put the upper handle In the operating
position.Tightenthe wlngnuts.
CAUTION:
Be careful when you fold or
raise the handle.
Do not damage
the
cables. Acablethet
Is bent will not work
correctly.
Before you use the unit, re-
plume a bent or damaged cable.
4. To aifash the renoll-stert
gdp to the rape
guide, twist the rope through the rope
guide mounted on the dght side ofthe han-
dle (Figure 2).
NOTE: If you
cannot
sttach
the
recoil-tort gdp because the rope Is too
short, hold the engine
stop lever
against the handle. Slowly pull the
recoil-start gdp.
Recoil-Start
Gdp
LowerHandle
Offset Hole
HOWTO ADJUSTTHE HANDLEHEIGHT
The lower handle has two assembly pesi-
_iens. A HIGH and a LOW position (Figure 3).
The HIGH pcalUon will raise the handle ap-
proximately four inches.
f
Figure
The mounting holes In the lower handle are
offset (Figure 1). To change the hole offset, ro-
tate the lower handle. This will change the
F-g852g
11
angle of the handle end make the height of the
handle higher or lower (Figure 3).
Removethe cabletias
thst festen the €on-
trol cables to the lower handle (Figure 4).
The cable tin can be re-used. To remove
a cable tle, pull the tab on the cable tle to
free the cable.
2. Remove the bolts and wlngnots
that fas-
ten the upper handle tothe lower handle.
3. Put the upper handle on the groundbe-
hind the mower.
CAUTION: Do not bend the control
cables. A cable that Is bent or damaged
must be replaced.
4. Remove the
wlngnuts
from the dght end
left handle brackets (Figure 1).
5. Remove the lower handle from the han-
dle breoksta (Figure 1).
Advertisement
Table of Contents
