Unpacking Instructions - Murray 22" Self-Propelled Instruction Book

22” self-propelled mower
Hide thumbs Also See for 22" Self-Propelled:
Table of Contents

Advertisement

UNPACKING INSTRUCTIONS

The mower was fully assembled at the factory.
When the mower was put in the carton, the
handle was put in the storage position. To put
the handle in the operating position, follow the
steps below.
Handle
1. Remove the mower from the carton.
2. Put the lower handle in the operating posi-
tion. Make sure the lower handle is be-
tween the locking tabs (Figure 1).
3. Put the upper handle in the operating
position. Tighten the knobs.
CAUTION: Be careful when you fold or
raise the handle. Do not damage the
cables. A cable that is bent will not work
correctly. Before you use the unit, re-
place a bent or damaged cable.
4. To attach the recoil-start grip to the rope
guide, twist the rope through the rope
guide mounted on the right side of the han-
dle (Figure 2).
NOTE:
If you cannot attach the
recoil-start grip because the rope is too
short, hold the engine stop lever
against the handle. Slowly pull the
recoil-start grip.
F-040411L
PREPARATION
11
Knob
Knob
Recoil-Start
Grip
Rope
Guide
Upper Handle
Lower Handle
Figure 1
Figure 2

Advertisement

Table of Contents
loading

Table of Contents