Removing A Hard Drive From A Hard-Drive Carrier; Installing A Hard Drive Into A Hard-Drive Carrier - Fortinet FortiManager-1000C Rack And Hardware Install Manual

Installing Hard Drives

Removing a Hard Drive From a Hard-Drive Carrier

Installing a Hard Drive Into a Hard-Drive Carrier

Installing a Hard Drive Into a Hard-Drive Carrier
FortiManager-1000C™ Version 4.0 Rack and Hardware Install Guide
02-40000-112634-20091026
http://docs.fortinet.com/ • Feedback
Remove the screws from the slide rails on the hard-drive carrier and separate the hard
drive from the carrier. See Figure 3.
1 Insert the hard drive into the hard-drive carrier with the connector end of the drive at
the back. See Figure
2 Align the screw holes on the hard drive with the back set of holes on the hard drive
carrier.
When aligned correctly, the back of the hard drive will be flush with the back of the
hard-drive carrier.
3 Attach the four screws to secure the hard drive to the hard-drive carrier.
Figure 3: Installing a Hard Drive into a Drive Carrier
2
1
1 hard-drive carrier
3 hard drive
1 Insert the hard drive into the hard-drive carrier with the connector end of the drive at
the back. See Figure 4 on page
2 Align the holes on the hard drive with the back set of holes on the hard drive carrier.
When aligned correctly, the back of the hard drive will be flush with the back of the
hard-drive carrier.
3 Attach the four screws to secure the hard drive to the hard-drive carrier.
3.
2
4
26.
3
4
screws (4)
SAS screw hole
25