Removing A Fortigate-5001Sx Module From A Chassis - Fortinet FortiGate FortiGate-5001SX Security System Manual

Hardware installation
8
9

Removing a FortiGate-5001SX module from a chassis

!
FortiGate-5001SX Security System Guide
01-30000-0380-20070201
Fully tighten the left extraction lever locking screw to lock the left extraction lever.
.
Mounting
Knot
Tighten
Locking Screw
Fully tighten the left and right mounting knots to lock the FortiGate-5001SX
module into position in the chassis slot.
If the chassis is powered on the PWR LED turns green and the STA LED turns
RED. The ACC LED also starts flashing red. After a few minutes, if the module is
operating correctly the front panel LEDs are lit as described in
Table 4: FortiGate-5001SX normal operating LEDs
LED State
PWR Green
ACC Off (Or flashing red when the system accesses the flash disk.)
STA Green
IPM Off
The following procedure describes how to correctly use the FortiGate-5001SX
mounting components shown in
FortiGate-5001SX module from a FortiGate-5000 series chassis slot.
To remove a FortiGate-5001SX module from a FortiGate-5000 series chassis
FortiGate-5001SX modules are hot swappable. The procedure for removing the
FortiGate-5001SX module from a FortiGate-5000 series chassis slot is the same
whether or not the FortiGate-5000 series chassis is powered on or not.
Caution: Do not carry the FortiGate-5001SX module by holding the extraction levers.
When inserting or removing the FortiGate-5001SX module from a chassis slot, handle the
module by the front panel. The extraction levers are designed for positioning and locking
the FortiGate-5001SX module into a slot in a chassis only and should not be used for
handling the module. If the extraction levers become bent or damaged the
FortiGate-5001SX module may not align correctly in the chassis slot and the left extraction
lever may not activate the power switch.
To complete this procedure, you need:
• A FortiGate-5000 series chassis with a FortiGate-5001SX module installed
• An electrostatic discharge (ESD) preventive wrist or ankle strap with
connection cord
Removing a FortiGate-5001SX module from a chassis
Figure 4 on page 14 to remove a
Table 4.
17