Pro-Form Strideclimer 710 I User Manual page 9

7. Insert the axle of the Roller (27) through the
right Link Arm (25); make sure that the Roller
is on the inner side of the Link Arm. Attach
the Roller with an M10 x 15mm Screw (71) and
an M10 x 22mm x 1.5mm Washer (63). Tip:
Use a wrench to hold the axle of the Roller
firmly in place while you tighten the Screw
into the axle.
Repeat this step to attach the other Roller
(27) to the left Link Arm (25).
8. Orient a Pedal (26) as shown. Attach the Pedal
to the bracket on the Left Pedal Leg (24) with
two M8 x 55mm Screws (61) and two M8 Hex
Nylon Locknuts (77).
Repeat this step to attach the other Pedal
(26).
All manuals and user guides at all-guides.com
9
7
25
27
8
26
61
24
26
25
63
71
77