Motor Cooling; Storing The Machine - Stihl MSE 220 Instruction Manual

Chain Pitch
type
Picco 3/8" P
Rapid 1/4"
Rapid 3/8"; 0.325" 6.0 mm
Rapid 0.404"
If groove depth is less than specified:
: Replace the guide bar.
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
MSE 220

Motor Cooling

Minimum
groove
depth
5.0 mm
4.0 mm
7.0 mm
Cooling air flows to the motor through
the slots in the front handle.
: Use a dry brush or similar tool to
clean the cooling slots at regular
intervals (see "Maintenance
Chart").

Storing the Machine

For periods of about 3 months or longer:
: Remove and clean the saw chain
and guide bar, spray with corrosion
inhibiting oil.
: Thoroughly clean the machine,
paying special attenton to the
cooling slots.
: If you use biological chain and bar
lubricant, e.g. STIHL Bioplus,
completely fill the chain oil tank.
: Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
English
29