Stihl MSE 220 Instruction Manual page 9

Hide thumbs Also See for MSE 220:
Table of Contents

Advertisement

Available languages

Available languages

English
In this regard use good work practices
and follow the recommendations of
OSHA / NIOSH and occupational and
trade associations. When the inhalation
of toxic dust, mists and fumes cannot be
eliminated, the operator and any
bystanders should always wear a
respirator approved by NIOSH / MSHA
for the type substance at issue.
!
Warning!
Breathing asbestos dust is dangerous
and can cause severe or fatal injury,
respiratory illness or cancer. The use
and disposal of asbestos containing
products have been strictly regulated by
OSHA and the Environmental Protection
Agency. Do not cut or disturb asbestos,
asbestos containing products (e.g.
asbestos containing drywall or other
construction products), or products such
as pipes which are wrapped or covered
with asbestos insulation. If you have any
reason to believe that you might be
cutting asbestos, immediately contact
your employer or a local OSHA
representative.
8
Don't work alone. Keep within calling
distance of others in case help is
needed.
Your chainsaw is equipped with a chain
catcher. It is designed to reduce the risk
of personal injury in the event of a
thrown or broken chain. From time to
time the catcher may be damaged or
removed.
To reduce the risk of personal injury, do
not operate a chainsaw with a damaged
or missing catcher.
!
Warning!
Avoid stumbling on obstacles such as
stumps, roots or rocks and watch out for
holes or ditches. Clear the area where
you are working. Be extremely cautious
when working on slopes or uneven
ground. There is increased danger of
slipping on freshly debarked logs.
!
Warning!
To reduce the risk
of serious or fatal
injury to the
operator or
bystanders, never
use the saw with one hand.
You cannot control reactive forces and
you may lose control of the saw, which
can result in the skating or bouncing of
the bar and chain along the limb or log.
Cutting Instructions
Grip: Always hold the saw firmly with
both hands when the engine is running.
Place your left hand on front handle bar
and your right hand on rear handle and
throttle trigger. Left-handers should
follow these instructions too.
Wrap your fingers tightly around the
handles, keeping the handles cradled
between your thumb and forefinger. With
your hands in this position, you can best
oppose and absorb the push, pull and
kickback forces of your saw without
losing control (see section on reactive
forces). Make sure your chainsaw
handles and grip are in good condition
and free of moisture, pitch, oil or grease.
MSE 220

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents