Optional Accessories; Protecting The Environment; Rechargeable Battery Pack; Troubleshooting - DeWalt XR LI-ION DCGG571 Manual

English
5. Once clean, reinsert the filter into the round groove,
ensuring it is fully seated, and reattach the grease tube
assembly to the grease gun.

Optional Accessories


WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.

Troubleshooting

Problem
Unable to pull back rod
Unable to push rod forward
No grease when trigger is pulled
Grease appears in relief valve
Motor does not run when trigger is pulled
Grease leaks out of the back of the grease tube
14
Please recycle electrical products and batteries according to local
provisions. Further information is available at www.2helpU.com.

Rechargeable Battery Pack

This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
WALT recommended
e •
•
Possible Cause
Vacuum build up
Pressure build up
Rod is still connected to plunger
Grease tube is empty
Air pockets in the grease tube
Check valve is clogged
Filter is clogged
Zerk fitting is blocked
Battery
Rubber seal is flipped the wrong direction
Run the battery pack down completely, then remove it from
the tool.
Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly
Possible solution
Unscrew the purge valve to release vacuum.
Unscrew the purge valve to release pressure.
Rotate grease tube handle 90 degrees to disengage it.
Add grease.
Refer to Purging Air Pockets.
Refer to Cleaning Contamination from the
Check Valve.
Refer to Cleaning Contamination from the Filter.
Disconnect coupler from fitting, clean zerk fitting and
grease path.
Make sure the battery is fully charged.
Refer to Preparing the Grease Gun for Suction
and Filler Pump Filling.