Disc Operations; Simple Playback Operations; Time Display Modes; Track Search - Tascam CC-222MK Owner's Manual

4- Disc operations

Simple playback operations

WARNING
If you are monitoring using headphones, first adjust
the level control to low on the unit, then connect to
the PHONES jack before playing back. This will pre-
vent any possible damage to your hearing.
1 Press the OPEN/CLOSE
2 Discs should be inserted in the tray with the label
uppermost.
3 Press the
OPEN/CLOSE
When a disc is loaded into the unit, the display briefly
shows , with a flashing period as the
TOC Reading.
unit determines the contents of the disc. When the TOC
has been read, the display shows (at the left of the dis-
play) one of the following:
CD Commercial pre-recorded CD
CD-R/CD-RW Finalized CD-R or CD-RW
CD-R, NO TOC CD-R which has yet to be finalized
CD-RW, NO TOC CD-RW which has yet to be finalized

Time display modes

When playing back a CD, or when in standby mode,
there are four different time display modes.
In each mode, the current track number is given, fol-
lowed by the time, as given below, e.g.
10Tr 0:48
Press the DISPLAY key to cycle through these time dis-
play modes, as described here:

Track search

Use the (or the
MULTI DIAL
control unit) to jump forward or backward by one track
at a time, as shown on the display.
Note that going forward from the last track of the disc
will "wrap round" to track 1, and going backward from
the first track of the disc will "wrap round" to the last
track of the disc.
It is also possible to use the number keys on the remote
control unit to jump directly to a particular track:
1 To play tracks 1 through 9, simply press the ap-
propriate key (1 through 9).
2 To play a track whose number is higher than
9, press the +10 key an appropriate number of
times to set the " tens" digit of the track number,
1
TASCAM CC-222MKIII
key to open the disc tray.
key to close the tray.
keys on the remote
SKIP
4 Press the key to start playback
PLAY
5 Press the STOP key to stop playback
6 Press the PAUSE key to pause playback tempo-
rarily.
To resume playback, press the
or the key.
PLAY
The track number indicators at the bottom of the dis-
play light, to show the available tracks playing back.
If there are thirteen tracks on the disc, for example,
indicators 1 through 13 will light. If there are more than
20 tracks on the disc, "OVeR" will light at the end of the
track number indicators.
Display shows Meaning
TOTAl
Total elapsed time of the disc
TOTAl ReMAiN
Time remaining of the current disc
[blank] Elapsed time of the current track
ReMAiN
Time remaining of the current track
NOTE
If the Program playback has been selected (see
"Program playback" on page 17), the elapsed time
and total remaining time refer to the programmed
material, not the whole disc.
followed by a single key to set the " units" digit.
For example:
Track 13 = +10, 3
Track 30 = +10, +10, +10, 0
NOTE
On the remote control unit only, the search keys
can be used to "fast-forward" and "fast-rewind"
through the disc.
PAUSE key again