Synchronized Recording; Automatic Track Division; Manually Divide Track - Tascam CC-222MK Owner's Manual

Synchronized recording

Synchronized recording basically means that recording
will begin automatically when a signal is received, and
will stop when the signal ends.
To enable or disable synchronized recording:
1 A recordable disc must be loaded.
2 With the unit in record standby mode or record
mode, press the SYNC REC

Automatic track division

The trigger level can also be used to divide tracks if the
auto track function is enabled.
NOTE
When recording Vinyl to CD, since the track divi-
sions are determined by relative silence, it is pos-
sible that spurious track divisions will be inserted.
Under these conditions, it may be better to set
this function off, and use manual track division
explained below.
When this function is enabled, the unit automatical-
ly inserts a track division in the recorded material.
Following modes are available for this function, and
are displayed as described.
•
LEVEL
When the sound level has dropped below the thresh-
old for more than two seconds, and sound has
re-started, the track will be divided.
level
A_LVL
(digital direct)
• DD
When recording digitally from MD, CD or DAT, this
mode detects a track boundary and divides the track.
However, when the DD mode is on, and if the analog
source or non-DAT/CD/MD digital connections are
detected, the track number will be incremented using
level detection.
key.
At least
2 seconds
Track increment
time
5- Recording CDs 1- Introduction Recording CDs
The display shows
SYNC ON
changes to the track and time display. When syn-
chronized recording is enabled, the sYNc indica-
tor lights in the display.
The SYNC REC key is also used to turn off syn-
chronized recording.
• TIME
The track will be incremented as passing the time set
before recording using "A_TIME" in the menu items
(see "Menu operation" on page 15). The time can be
set 1 minute to 10 minute increased by a minute.
• OFF
This sets the function disabled (no indicator lit).
To enable or disable automatic track
ª
division:
1 While record standby mode, press the
repeatedly until the display shows
where is the current setting.
XXX
2 Use the MULTI DIAL or
desired auto track setting.
The A_TRAcK indicator lights at the right of the
display.
When the mode is selected, the indicator
TIME
will blink.

Manually divide track

While recording is taking place, press the
key. The current track number is incremented by one.
NOTE
This operation cannot be applied while recording
track 99.
briefly, and then
MENU key
A_TRK> XXX
SKIP keys to select the
RECORD

TASCAM CC-222MKIII