Table of Contents
Advertisement
Installation
Monitor back cover
Make sure that all cables are connected and then lead them down through the cable duct on the back side of the
column. Slide the duct cover of the column into place. Make sure that all cables come out at the bottom of the
column without being squeezed by the duct cover.
The monitor back cover is kept in place by magnets. Place the cover against the magnetic points on the monitor
frame as shown in Figure 7.
Duct cover
Figure 7
When everything is mounted correctly, the TANDBERG 7000
should look like shown in Figure 8.
TANDBERG Videoconferencing System
18
NOTE
T
HE FRONT COVER OF THE MONITOR FRAME IS
MADE OF PLASTIC AND SHOULD BE TREATED WITH
.
CARE
Figure 8
Advertisement
Table of Contents
