Bosch NDP-7512-Z30C Installation Manual page 25

AUTODOME IP starlight 7000i
Figure 7.5: Attach Housing to Interface Box
1.
2.
3.
Figure 7.6: In-Ceiling Housing and Interface Box
1
2
3
Caution!
The In-ceiling dome is provided with tether points on each side of the housing. To prevent
!
injury, attach a safety wire from a secure anchor point above the ceiling to a tether point on
the dome housing. See below for an illustration.
Bosch Security Systems
Insert the In-ceiling housing through the hole in the ceiling to verify that the edge of the
hole support the unit. Then remove the housing from the hole.
Align the ball studs of the In-Ceiling Housing to the Stud Retainers on Interface Box and
attach.
Tighten the two (2) Thumbscrews to secure the Interface Box to the housing.
Interface Box
Ball Stud
In-ceiling Housing
4
5
6
Installation Manual
Installing the In-Ceiling Mount | en
Thumb Screw
Tether Point
Ceiling Clamp
2019-09 | 0.8 |
25