Cleaning Your Arc Trainer 425A - CYBEX Arc Trainer 425A Owner's Manual

Cardiovascular systems
Hide thumbs Also See for Cybex Arc Trainer 425A:
Table of Contents

Advertisement

Cleaning Your Arc Trainer 425A

WARNING: To prevent electrical shock, be sure the unit is unplugged from the electrical outlet
before performing any cleaning or maintenance procedures.
When cleaning your unit spray a mild cleaning agent, such as a water and dish soap solution, on a
clean cloth first and then wipe the unit with the damp cloth.
NOTE: Do not spray cleaning solution directly on the unit. Direct spraying could cause damage to the
electronics and may void the warranty.
After Each Use - Wipe up any liquid spills immediately. After each workout, use a cloth to wipe up any
remaining perspiration from the handles and painted surfaces.
Be careful not to spill or get excessive moisture on the console and display overlays, as this might
create an electrical hazard or cause failure of the electronics.
As Needed - Vacuum any dust or dirt that might accumulate under or around the unit. Cleaning this
area should be done as often as indicated in the Service Schedule.
WARNING: Keep wet items away from inside parts of the unit. Electrical shock could occur
even if the unit is unplugged. Do not touch components on the lower board. A
charge can remain after unplugging the power cord.
To clean inside the unit, remove the four Phillips head screws securing the access cover in place. Use
a vacuum attachment or hand vacuum to clean the exposed elevation assembly and remove dirt and
debris off of internal components.
Use a dry cloth to wipe all exposed areas. Replace the access cover and secure it with the screws when
finished.
Lift the rear of the unit and roll it back from its present position so as to vacuum the floor area
underneath the unit. When finished, return the unit to its normal position.
Contact Heart Rate Grips - Contaminants, such as hand lotions, oils or body powder, may come off
on the contact heart rate grips. These can reduce sensitivity and interfere with the heart rate signal. It is
recommended that the user have clean hands when using the contact heart rate. Clean the grips using
a cloth dampened with a cleaning solution containing alcohol. The grips are the only part of the unit you
should use a cleaning solution containing alcohol.
Preventive
Maintenance
Page 4-2
Cybex Arc Trainer 425A Owner's Manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents