Displaying Heart Rate; Heart Rate Led - CYBEX Arc Trainer 425A Owner's Manual

Cybex Arc Trainer 425A Owner's Manual
To review accumulated data after a program: The display automatically cycles through your
accumulated workout data during the Workout Review for 20 seconds (default setting). NOTE: Heart
rate is not displayed during a Workout Review.

Displaying Heart Rate

In order to display your heart rate, you must either use a Polar compatible heart rate transmitter belt (not
included) or hold the handgrips to use Contact Heart Rate.
Contact Heart Rate - Hold the handgrips on the handles until a heart rate is displayed, typically less
than thirty seconds. For best results, hold the handgrips lightly and ensure that your hands contact both
the front and back sensors of each grip. NOTE: Hold your hands as steady as possible as
movement can cause interference on the contacts.
Factors that can interfere with the heart rate signal include:
• excessive movement
• body composition
• hydration
• too loose grip
• too tight grip
• excessive dirt, powder or oil
• resting or leaning on the grips
Contaminants, such as hand lotions, oils or body powder, may come off on the contact heart rate grips.
These can reduce sensitivity and interfere with the heart rate signal. Therefore, ensure you have clean
hands when using the contact heart rate.
Polar Compatible Reception - To use this feature, a Polar compatible heart rate transmitter belt must
be worn. To view heart rate continuously, press the Scan key when the Heart LED is lit or press the
Heart key.

Heart Rate LED

When the handgrips are held the center display switches to show the heart rate in beats per minute
(BPM) if you are not scanning. For several seconds the display will show "---". Once the actual heart
rate is determined the center window displays the BPM and the Heart LED lights up. See Figure 2. The
color of the light represents a scale of low to high target heart rate.
Operation
Page 3-7