Cleaning Your Arc Trainer 610A - CYBEX Arc Trainer 610A Owner's Manual

Cardiovascular systems
Hide thumbs Also See for Arc Trainer 610A:
Table of Contents

Advertisement

Cleaning Your Arc Trainer 610A

! WARNING: To prevent electrical shock, be sure that power is shut off and the unit is unplugged
When cleaning your unit spray a mild cleaning agent, such as a water and dish soap solution, on a
clean cloth first and then wipe the unit with the damp cloth.
NOTE: Do not spray cleaning solution directly on the unit. Direct spraying could cause damage to the
electronics and may void the warranty.
After Each Use - Wipe up any liquid spills immediately. After each workout, use a cloth to wipe up any
remaining perspiration from the handrails and painted surfaces.
Be careful not to spill or get excessive moisture on the console and display overlays, as this might
create an electrical hazard or cause failure of the electronics.
As Needed - Vacuum any dust or dirt that might accumulate under or around the unit. Cleaning this
area should be done as often as indicated in the Service Schedule.
! WARNING: Keep wet items away from inside parts of the unit. Electrical shock could occur
To clean inside the unit, remove the four Phillips head screws securing the access cover in place. Use a
vacuum attachment or hand vacuum to clean the exposed elevation assembly and remove dirt and
debris off of internal components.
Use a dry cloth to wipe all exposed areas. Replace the access cover and secure it with the screws
when finished.
Lift the rear of the unit and roll it back from its present position so as to vacuum the floor area
underneath the unit. When finished, return the unit to its normal position.
Contact Heart Rate Grips - Contaminants, such as hand lotions, oils or body powder, may come off
on the contact heart rate grips. These can reduce sensitivity and interfere with the heart rate signal. It is
recommended that the user have clean hands when using the contact heart rate. Clean the grips using
a cloth dampened with a cleaning solution containing alcohol. The grips are the only part of the unit
you should use a cleaning solution containing alcohol.
Preventive
Maintenance
Page 4-2
Cybex Arc Trainer 610A Owner's Manual
from the electrical outlet before performing any cleaning or maintenance
procedures.
even if the unit is unplugged. Do not touch components on the lower board. A
charge can remain after unplugging the power cord and turning off the unit.

Advertisement

Table of Contents
loading

Table of Contents