Kenmore Smart Water Heater Module Quick Start Install Manual page 7

2
Install the Smart
Water Heater Module
(Cont'd)
If you have a heat pump water heater, follow these steps:
Step 1: Turn power off at source (circuit breaker).
Figure 3:
Control panel shown;
Located on front of
water heater.
NOTICE: Do not turn power on unless screws are installed as described in
Step 4 above. Screws must be installed to prevent equipment damage.
Step 2: Remove plug access cover. Discard screws.
Longer screws are provided.
Step 3: Plug in module.
Step 4: Secure the module with
Step 5. Go to Section 3.
the longer screws that are
provided (2).