Kenmore Smart Water Heater Module Quick Start Install Manual page 12

5
Enable the Water Heater
(Cont'd)
Follow these steps if you have a heat pump
water heater. Otherwise, go to Section 6.
Step 1: After turning power on, wait for
the diagnostics to run. It will
take up to eight minutes for the
water heater to complete its
diagnostics. The controller will
initialize when the diagnostics are
fi nished.
Step 2: Press the Mode button for fi ve seconds.
The screen will
display the
following:
1. r.A (3 seconds;
this means
Remote Access
not enabled; local
control only).
2. 120F (3 seconds;
indicates temp.
set point.
Figure Figure 6: Heat
Pump User Interface and
Controller
Hold for Remote Access
Hold for Vacation
Hold for °F/°C
Enable / Disable