Kenmore Smart Water Heater Module Quick Start Install Manual page 6

Hide thumbs Also See for Smart Water Heater Module:

Install the Smart

Water Heater Module

WARNING! Working on an energized circuit can result in severe injury or

death from electrical shock. Turn power oﬀ before performing this installation.

Check wires with a non-contact circuit tester to make sure power is oﬀ .

If you have a smart electric water heater, follow these steps:

NOTICE: Do not turn power on unless screws are installed as described in Step

4 above. Screws must be installed to prevent equipment damage.

Step 1:

Turn power oﬀ at source (circuit breaker).

Step 2: Remove access cover. Discard screws.

Longer screws are provided.

Step 3: Plug in module.

Step 4: Secure the

module with the

longer screws that

are provided (2).

Step 5:

Go to Section 3.

Figure 2: Top of Heater

Table of Contents