Kenmore Smart Water Heater Module Quick Start Install Manual page 11

5
Enable the Water Heater
Follow these steps if you have a smart electric water heater with a control
panel (shown below).
If you have a heat pump water heater, skip these steps and go to the next
page.
Step 1: Watch the water heater's display screen for the Remote Access icon
to appear (Figure 5). This may take a minute after the power has
been turned on.
Remote Access Button
ENERGY STANDARD
SAVER
ELEMENT
Remote Access Icon
°F/°C
Lock Button
Figure 5:
Water Heater Control Panel
VACATION REMOTE
ACCESS
F
ALERT REMOTE
ENTER
Step 2: Activate the screen by
touching any button, then releasing it.
Step 3: If the screen is locked, touch
and hold the Lock button for at least
5 seconds (Figure 5).
Step 4: Touch the Remote Access button
(Figure 5, top right). The Remote Access
button must be backlit before continuing
with setup.
Step 5:
Go to Section 6 and download the
app.