Note: If you fi nd a stud, choose new slots by starting at the beginning of this step again and using a stud fi nder to re-identify and marking new anchor locations.

G. After completing the six test holes, drill a ½-inch hole at each test location.

H. Place the fl oor support mount assembly back against the wall, aligning the six chosen mounting slots with the six drill holes.

Insert toggle bolts through each of the mounting slots and into the ½-inch holes in the wall.

Make sure that the toggle bolt keys are seated in the mounting slots.

K. Tighten each bolt enough to keep the key secure in the slot.

L. When all anchor bolts are inserted, fully tighten the toggle bolts to secure the stand to the wall.

WARNING: Ensure screws are securely tightened

To reduce the risk of the product falling, ensure that all screws are securely tightened before mounting the display. Do not over tighten.

Step 3: Attach the hanger bars to the Surface Hub

A. Place one of the hanger bars over the left mounting screw holes on the back of Surface Hub.

Note: The tightening screw is located at the base of the hanger bar. The base of the hanger bar should face down. The left mounting screw holes are the holes closest to the left edge of Surface Hub.

B. Using the hanger bar screws, attach the hanger bar to the mounting screw holes.

C. Tighten the screws securely.

WARNING: Ensure screws are securely tightened

To reduce the risk of the product falling, ensure that all screws are securely tightened before mounting the display. Do not over tighten.

D. Repeat these steps for the right side hanger bar.

Key seated in slot

Table of Contents