Microsoft Surface Hub 55" Assembly And Mounting Manual page 11

A. Confi rm that the hanger bar clamps are open.
Note: If the clamps are not fully open, turn the clamp screws counterclockwise to open them (see images below).
Top Hooks
Clamp Screw
B. Lift Surface Hub and align the top hooks of the hanger bars with the top edge of the wall plate.
Not Engaged
C. Lift Surface Hub, aligning the top hanger bar hooks above the wall plate.
D. GENTLY lower Surface Hub to seat and rest the top hanger bar hooks on the top wall plate fl ange.
WARNING: Ensure hanger bar is resting on wall plate
Do not release Surface Hub until you are sure the hanger bars are properly seated on the wall plate.
E. Slide the lower hanger bar hook under lower wall plate fl ange.
F. Secure Surface Hub to the lower wall plate fl ange by tightening the hanger bar clamp screws.
WARNING: Ensure screws are securely tightened
To reduce the risk of the product falling, ensure that all screws are securely tightened before mounting the display. Do not over tighten.
Clamp Open Clamp Closed
K
Fully Engaged
9