Do not attempt to install the device with fewer than the required number of individuals. To reduce the risk of injury due to the size and weight of the device, keep the device upright. When placing the device onto the mount, be certain it is

properly seated before releasing it. Keep the assembly area clear of packing materials. Remove materials after each step.

WARNING: Designated Load Capacity

Wall mounts are rated for a designated load capacity. To reduce risk of personal injury, death, or damage to the device, never exceed the designated load capacity of the wall mount. Refer to the specification section for weights and

load capacities.

WARNING: Tip-Over and Fall Hazard

The wall mount is designed to handle the weight of the device. To reduce the risk of injury or death, never allow anyone to hang from the unit. Never suspend anything other than the designated device.

WARNING: Do Not Attempt to Repair or Modify

Assemble mount components using only fasteners provided by Microsoft, as shown on the parts list. Do not attempt to take apart, open, service, or modify the product, accessories, or power supply. Doing so could present the risk of electric

shock or other hazard. Any evidence of any attempt to open and/or modify this device, including peeling, puncturing, or removing any of the labels, will void the Limited Warranty. Heed all warnings and follow all instructions.

WARNING: Electrical outlet location

To reduce risks related to electric shock, ensure that there is an appropriate electrical outlet within reach of the power cord provided with device to be mounted. Do not use extension cords, or a power cord other than what is provided with the

display assembly.

WARNING: Pinch hazard

When mounting the wall support and installing the device, take care to avoid pinching fingers.

WARNING: Choking hazard

This device or its accessories may contain small parts, which may be a choking hazard to children under 3. Keep small parts away from children.

WARNING: Small children

This device and its accessories are not toys. To reduce the potential for injury, death, or product damage, do not allow small children to play with them. Never allow children to climb on or hang from the device or its stand.

WARNING: Mounting surface orientation

The wall mounting assembly is designed for vertical surfaces only. To reduce the risk of injury or death, do not mount to any surface other than a vertical wall. Do not mount in any orientation other than landscape.

WARNING: Ensure screws are securely tightened

To reduce the risk of the product falling, ensure that all screws are securely tightened to their specified torque values. Do not overtighten as this may cause damage and weaken the holding strength.

This guide outlines the steps for assembling the Surface Hub 55" and Surface Hub 84" floor support mount. These mounts require two people to assemble. Before you begin, make sure you have all of the components in the parts list.

IMPORTANT: Avoid damage to your device.

support it to keep it vertical. The Surface Hub 84" is intended to be lifted only by the lifting handles when being carried. Do not place either device on its face, back, top, or sides.

Specifications

Model

Device

Stand

weight

Surface Hub 55"

105 lb.

60 lb.

Surface Hub 84"

250 lb.

80 lb.

Required tools (not included)

#2 Phillips screwdriver

5mm hex key

6mm hex key (84" only)

8mm hex key

Hand Drill

7/32-inch drill bit

3/16-inch drill bit

Level

Stud finder

Torque Wrench with 5mm and 6mm hex bits

10mm Socket

Further specifications for Surface Hub can be found at http://www.microsoft.com/surface/support/surface-hub

The Surface Hub 55" may be supported only by its bottom edge when not supported by the mounting system or lifting handles. Rest it only on its bottom edge, and

Handle

Designated

weight

load capacity

165 lb.

30 lb.

360 lb.

Table of Contents