Acura 2011 RDX Owner's Manual page 179

To Select a Station
You can use any of five methods to
find radio stations on the selected
band: tune, seek, scan, the preset
bars, and auto select.
TUNE － Use the TUNE/FOLDER
bar to tune the radio to a desired
frequency. Press the
bar to tune to a higher frequency,
and the side of the bar to tune to
a lower frequency.
If you press and hold the
side of the bar, the frequency will
begin to change rapidly. It will stop
when you release it.
SEEK － The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the or side of the
SEEK/SKIP bar, then release it.
Playing the FM/AM Radio (Models without navigation system)
SCAN － The SCAN function
samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. You will see ''SCAN''
on the center display. When it finds a
strong signal, it will stop and play
that station for about 10 seconds.
side of the
If you do nothing, the system will
then scan for the next strong station
and play it for 10 seconds. When it
plays a station you want to listen to,
or
press the SCAN button again.
2011 RDX
Preset － Each side of the bars
(1－6) can store one frequency on
AM and two frequencies on FM.
1. Select the desired band, AM or
FM. FM1 and FM2 let you store
two frequencies with each side of
the preset bar.
2. Use the TUNE, SEEK, or SCAN
function to tune the radio to a
desired station.
3. Pick the preset number (1－6), for
the station you want to store. Press
the left or right side of the bar, and
hold it until you hear a beep.
4. Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
CONTINUED
175