Changing The Engine Oil And Filter - Acura 2011 RDX Owner's Manual

Changing the Engine Oil and Filter

Always change the oil and filter
according to the maintenance
messages shown on the multi-
information display. The oil and filter
collect contaminants that can
damage your engine if they are not
removed regularly.
Changing the oil and filter requires
special tools and access from
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lift for this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
technician.
422
OIL DRAIN
BOLT WASHER
1. Run the engine until it reaches
normal operating temperature,
then shut it off.
2. Open the hood, and remove the
engine oil fill cap. Remove the oil
drain bolt and washer from the
bottom of the engine. Drain the oil
into an appropriate container.
2011 RDX
3. Remove the oil filter, and let the
remaining oil drain. A special
wrench (available from your
dealer) is required.
OIL
FILTER
4. Check the oil filter to make sure its
gasket did not stick to the filter
base. A stuck gasket could cause
an oil leak.
5. Install a new oil filter according to
the instructions that come with it.